Restoration: Connecticut's State Warbird
What World War II fighter was a product of the Nutmeg State?
- By James Wynbrandt
- Air & Space magazine, January 2010
In 2005, the Connecticut legislature unanimously declared the Chance Vought F4U Corsair, the renowned World War II fighter with an inverted gull wing, its Official State Aircraft.
“It was a no-brainer,” says Craig McBurney, a driving force behind the effort. “It’s the only aircraft designed and built in one state by one major corporation in World War II,” he says of United Aircraft, the parent company of the manufacturers that built the airframe, engine, and propeller. The Corsair would have needed long, and thereby heavy, landing gear to give the massive 13-plus-foot propeller ground clearance. So engineers canted the wings, allowing for shorter, lighter landing gear at each wing’s low point. The F4U started life with the 2,000-plus-horsepower Pratt & Whitney R-2800 Double Wasp radial, which, at the time it was introduced, was the most powerful fighter engine.
Of more than 12,500 Corsairs built, fewer than 20 are flying today. “Even most people who don’t know airplanes know the airplane,” says McBurney.
He’s speaking inside a World War II-type Quonset hut he re-created out of a hangar at Connecticut’s Chester Airport, headquarters for Connecticut Corsair, the organization he founded to restore a wrecked F4U-4 he bought in 1993, registration number N5222V (originally Bureau Number 97330). The scarred mid-section of the fuselage is the largest piece. A canopy, wing ribs, and other parts hang from the ceiling. Others lie in crates stacked on shelves that reach the roof.
McBurney and his dozen or so volunteers are also digitizing some 20,000 blueprints with the help of modeling software SolidWorks and a scanning device at another company, Bolton Works. This enables 3-D modeling and computer-aided design and manufacturing of new parts, as skilled workers able to make parts by hand are scant and expensive. About 30 percent of the airplane will be newly fabricated.
Yet the team will rely on some traditional construction techniques. “It’s still hand-assembled, and the assembly sequence is critical,” McBurney says.
Daryl Retzke and Matt Sandberg, 20-something engineers, display 3-D blueprints on a computer, which provide manufacturing instructions to a machine.
“For me, this project goes back to the roots of engineering,” Retzke says. “This great airplane was designed by pencil and slide rule.” Studying it piece by piece “makes me a better, more grounded engineer, basically bringing me back to the fundamental instruments and techniques used for design.”